Home Phone

Home Phone Number: 604-986-7541

The house phones are a wired base station with three wireless handsets.

The base station is wired to the Shaw Phone Modem in the Utility Room.

Vtech Corless Phones (DS6670-6C)

• Full User Manual

  • Replacement Battery (283342)

  • Replacement Handset (DS6071)

Remote access

A two-digit security code is required to access the answering system remotely from any touch-tone telephone.

• • Dial your telephone number from any touch-tone telephone.

  • When the system plays your announcement, enter the two-digit security code.

  • Enter one of the following remote commands.

1 = Play all messages

2 = Play new messages

3 = Delete the current message (during playback)

33 = Delete all old messages

4 = Repeat the current message (during playback)

5 = Stop

*5 = Hear a list of remote commands

6 = Skip to the next message (during playback)

*7 = Record a new announcement.

8 = End the call

0 = Turn the answering system on or off.

• • Hang up or press 8 to end the call.

  • If you do not press any keys after you enter the remote access code, all new messages play.

  • If there are no new messages, all old messages play.

  • Once the new messages have played, the telephone announces the help menu options.

  • If you do not press any key within 20 seconds, the remote access call automatically disconnects.

  • When the answering system memory is full, the telephone announces “Memory is full. Enter the remote access code.”

To register a headset

• • Place the non-registered headset in the telephone base and allow it to charge for at least 15 minutes before beginning registration.

  • Remove the headset from the telephone base.

  • The light on the headset flashes slowly and alternately in red and blue.

  • On the telephone base, press and hold FIND HANDSET for about four seconds until the red IN USE light turns on.

  • Immediately place the headset in the telephone base.

  • It takes about 60 seconds to complete the registration.

  • The red IN USE light on the telephone base turns off.

  • The light on the headset turns red when it is registered but not fully charged, or turns blue if it is registered and fully charged.

    • If registration is successful, you hear a dial tone when you press on the headset.

    • If registration fails, you hear “Not registered” through the headset earpiece when you press on the headset.

  • The light on the headset flashes slowly and alternately in red and blue.

  • To reset the headset, remove it from the telephone base and then place it back into its charger. Try the registration process again.